The Stelpro BA1T1W is a built-in single-pole mechanical thermostat for the Stelpro Bella (BA) high-end baseboard, rated for 120 V to 600 V. It mounts inside the baseboard's left or right junction box, and its knob fits through the front cover, so the heater is set right at the unit.
Field-Installed Kit
The BA1T1W is the kit for installing on site. Stelpro also offers the same thermostat factory installed on the left side (BA1T1W-G) or right side (BA1T1W-D) of a new Bella baseboard. Stelpro lists the built-in thermostat as an optional control for the Bella and strongly recommends using an electronic thermostat.
Installation
With the power off at the breaker, remove the baseboard's front cover and drill a 1/2 in. hole in the end of the cover on the thermostat side. The thermostat attaches to its bracket with the small screws provided, and the bracket fixes to the junction box frame with the shaft lined up with the side knockout. The single-pole model connects with two black wires: one to the wire coming out of the wireway and one to the line feed. The knob then goes through the front cover onto the thermostat shaft. Stelpro specifies installation by a qualified person and connection by a certified electrician, following the electrical and building codes in effect.